The holes for the side position markers have been drilled and the dots places. On the Headless neck I used a 3/32" bit for the slightly larger white dots. On the Firebird neck I used a brad point 2mm bit. I think I prefer the slightly larger bit. Unfortunately the 3/32" bit is not a brad point and has a tendency to drift slightly causing the dots to be drilled slightly off from the desired spot.
On Saturday I carved the back of profile of the headless neck. I started our using a microplane at two spots on the neck, behind the 1st fret and about 4 inches from the base. Then I used a rasp to smooth out the wood. After I finished the two spots on the neck I used a spoke shave to remove wood between the spots I worked on. After taking off the excess wood I used a fine rasp to smooth the wood. Once I finished the rough profile, I proceeded to sand paper, first 80 grit then moving on to 220 and ending with 320. This is still a rough neck and will require more sanding to even out the profile.
On Sunday, I worked on the Firebird neck. I went through the same process as I did above with the Headless neck. Pictures are below.
